We should all know that the panel hot press is a kind of hot press, of course, they have many similar points. But recently, some friends said that when using the panel hot press, his heat presented a problem, the specific problem is not known, in order to help us deal with this problem, special to collect some materials, the specific content is as follows.

The intent of the veneer hot press

Standard operating procedures to ensure safe production.

The scope of application of veneer hot press

1. This regulation shall be observed when using hydraulic press and hot press for gluing of in-and-out material.

2. The operator must be trained and qualified before taking up the post. Non-local operators are not allowed to operate the machine.

3. The operator needs to wear good work clothes, and its energy must be highly concentrated during operation.

4. Clean the working place of the machine (including the dirt on the light plate) before operation.

5. Check the oil bed before operation to see if there is oil leakage in the oil circuit. Check whether the pump circulation switch is turned on.

6. After test, preheat the press.

7. First sweep the dust on the surface of the workpiece during operation. If there is oil, it is necessary to clean it and then coat it with uniform glue.

In the process of operation, the hot press needs to be useful to cover the workpiece after gluing and put it into the press. Adhere to the press clean and uniform force, adhere to the oil switch in the open state. During rapid warm-up, the operator can not leave the post and adjust at any time. The time before and after the workpiece is placed into the press shall not exceed half a minute. During the lifting of the press, it is forbidden to extend your hand into the press. After use, the press should adhere to the closed condition.

If there is a problem with our panel hot press, it will not only affect its own service life, but also affect the quality of the plywood, so we must protect the panel hot press to ensure that it can operate normally. However, when using the panel hot press, the heat flow is often encountered, which has a great impact on the quality of our products, so we need to deal with this problem. I don't know if we have any good solutions to share with us.

If there is heat backflow in the hot press, then we must first see if the heat of the hot press plate is the same, and together we must ensure that the hot press is smooth, and then separate it with asbestos on the top and bottom layers, so that the first thing is to avoid the hot press due to too much heat and damage. This method can be very good to avoid the heat in the hot press in the panel, if you don't believe it, try it. Friends who want to buy panel hot press can also contact us at Wuxi Ouliwei Machinery Manufacturing Co., LTD.