Operating procedures for veneer hot press machine

Now let's invite Wuxi Ouliwei Machinery Manufacturing Co., Ltd. to introduce it to usVeneer hot press machineOperating procedures：

Veneer hot press machineIt is a commonly used equipment for furniture, building materials and other professions, mainly used to stick PVC, veneer and other materials on the surface of boards to achieve decoration, protection and other functions. In order to ensure operation and improve work efficiency, the following are the operating procedures and precautions for the veneer hot press machine.

ONE、 Operation

1. Check if all parts of the hot press are intact and undamaged, and repair any problems promptly.

2. Use the power supply strictly according to the voltage requirements.

3. Before operation, it is necessary to wear protective equipment such as work clothes, work shoes, gloves, etc.

4. During operation, it is necessary to ensure clear visibility and no impact.

5. It is prohibited to wear close fitting clothing such as gloves, slippers, and long pants during operation.

TWO、 Operation method

1. Connect the power supply

Before connecting the power supply of the equipment, it is necessary to ensure the normality of the power interface, power cord, power switch and other components.

2. Select materials

Select the corresponding veneer materials based on the demand for hot pressed sheet materials.

3. Set the parameters of the veneer machine

Set various parameters of the hot press machine on the right side according to the scale of the hot pressed sheet, including temperature, time, pressure, etc., to ensure a reasonable combination of technical parameters.

4. Open the feeding door

Insert the board that requires hot pressing into the feeding door, and strictly cut it according to the specified dimensions of the equipment before operation.

5. Start hot pressing

After the equipment is started and the operation begins, adjust the height of the pressure head and rotate the hot press machine to reach the limit condition.

6. Arrange neatly

During the restriction of the board, the regularity of the board should be investigated at all times, and the position of the board should be adjusted in a timely manner to ensure that the board passes through a successful hot pressing process.

7. Complete hot pressing

After the hot pressing is completed, turn off the power supply of the hot pressing equipment in the order of operation and gently remove the board.

THREE、 Precautions

1. The hot press requires a dedicated person to operate and protect it.

To ensure the quality of veneers, it is necessary to check the temperature and adhesive condition of the equipment before each veneer, and it is necessary to comply with the prescribed specifications.

3. Excessive glue should not be added during private use, as this will not only result in a decrease in data quality, but also damage the equipment.

4. After each hot pressing process, it is necessary to clean the interior of the equipment, especially the pressure head and adjustment equipment. The equipment must not be disassembled or maintained until it has completely cooled down.

During the operation of the equipment, it is necessary to investigate each critical node, such as indicator lights, slitting machines, etc. Only in this way can a good thermal compression effect be achieved with sufficient time.

In summary, it is necessary to pay special attention to the operating procedures and skills during the use of veneer hot press machines. Only by operating in an orderly manner according to requirements and standards can we ensure the quality of veneer production and the smooth progress of production operations.